Consider cleaning and reusing or ordering from Richard Original bearings' inner race is designed for a slip fit newer 6202-5/8 bearings will have to be pressed on the spindle instead which makes the spindle non-interchangeable. These are not exact replacements as the original quill bearings were designed such that you could easily replace the quill with other designed for mortising or shaping, but for drill-only purposes these are suitable replacements. Newer style with wider (~.471 in) spacers: 6203 (bearing does not have extended inner race).Older style with narrow (~.325 in) spacers: 88503 (bearing has extended inner race).Given this conflict with the above data it might be best to wait until the motor is open before buying bearings. Note: I have a 1947 motor that says frame 180 Catalog No 87-010 and it takes New Departure 87504. 18 Drill Press (w/ external screw table lift) ¶ 1305 Double Row Self Aligning Ball Bearing (Qty.6005-LLNR with Snap Ring (25mm B, 47mm OD, 12mm W)īoth of these bearings are available through Accurate Bearing.They are located just below the spindle sheave: The following are the two upper bearings for the spindle. Quill: 6202-5/8 bore, Spindle pulley: 6204 & 6205ġ650 15" Bench Top Drill Press ¶ Photo Index for this type drill press.NDP15 Drill Press (floor and bench models)ī-4 Oscillating Spindle Sander and T-5 Titling Spindle SanderĪccurate Bearings comes highly recommended on the forum for replacements. Motor: Model 93-610 (2HP, 1725 RPM, capacitor start) Motor: Model 800 - 1/3 hp 1725 rpm Split Phase motorĭelta/Rockwell 10" Abrasive Cut-Off Saw (No. Motor: Model 924 - 3/4 hp 1725 rpm Repulsion Induction motor 62610 - 1/2 hp 1725 rpm Capacitor Start motor: frame 166, 5/8" double-end shaft V6920 - 1/2 hp 1725 rpm Capacitor Start motor: frame 165, 5/8" double-end shaft Motor: Model 62-110 - 1/3 hp 1725 rpm Capacitor Start motor Motor: Model 6400 - 1/3 hp 1725 rpm Repulsion Induction motor Motor: 3/4 hp 1725 rpm Repulsion Induction motor: frame 180 18 Drill Press (w/ external screw table lift)ĭelta/Crescent 20" Bandsaw (model 28-350 and 28-365 with rounded corner cabinet)ĭelta/Rockwell 4" Jointer (37-290, 37-110, 22-110)
0 kommentar(er)
